Sequences Menu - Aquatronica evolution ACQ110 Instruction Manual

This function lets you enable a set of user-defined phases consecutively so as to make executing
certain operations such as change of water easier.
NOTE: It is possible to create and modify a sequence only using PC software (see the
dedicated paragraph in the PC software instructions).
Sequences
Water Change
Sequence 2
(Fig. 1)
Do you confirm
enabling of the
selected sequence?
Enter: Confirm
Esc: Cancel
(Fig. 2)
Do you confirm
disabling of the
sequence?
Enter: Confirm
Esc: Cancel
(Fig. 3)
Sequences

Water Change
Sequence 2
(Fig. 4)
IsACQ110C-0 (ENG) Rev.230708-0

Sequences Menu

To enable the set sequence, proceed as follows:
Main screen  Main Menu  Sequences.
To enable a sequence, select it from those available and then
press the "Enter" key (Fig. 1).
Once a sequence is enabled, its icon (
lower left of the main screen and the outputs controlled by
the sequence are marked by the icon
If you want to cancel a sequence under execution, select the
same sequence again and press the "Enter" key.
Enabling a certain sequence is displayed with a flag next to
the name of the sequence.
WARNING
Two or more sequences cannot be executed at the
same time.
If you try to enable a sequence while another is being
executed, an error message will appear.
) appears on the
.
37 - 60