Xy Program Menu; Insert - Aquatronica evolution ACQ110 Instruction Manual

In this menu one or more programs can be set to turn one or more outlets on the power units on
or off (maximum of 3 per program), depending on the value assumed by two connected sensors.
This type of programming is commonly used for automatic aquarium replenishing, adding soft or
salt water according to the values supplied by the level sensor and density sensor.
Furthermore, a program can be run that doses via dosing pumps according to the value read by
one or more connected chemical sensors.
Main Menu
Settings
Power Unit
Function Keys
XY Programs
Agenda
(Fig. 1)
XY Programs

Insert

(Fig. 2)
From: 08.00
V1: Undefined
V2: Undefined
A1: Undefined
A2: Undefined
A3: Undefined
Max. time OFF
(Fig. 3)
IsACQ110C-0 (ENG) Rev.230708-0
XY Programs Menu
To access the sensor programming menu (Fig.1):
Main screen  Main menu  XY Programs
When the XY Programs menu appears, a program can be
inserted, viewed, edited or deleted.
When the first program is inserted, only the program's "Insert"
menu will be displayed (see Fig. 2); the "View/Edit/Del" and
"Delete All" menus will be shown later.
After pressing "Enter" on the screen in Fig. 2, a screen
(see Fig. 3) in which the program settings can be defined
will appear:
• It is possible to set the following in the upper part of the
screen:
- The time interval (From...To) within which the program
remains enabled.
- The two variables the program depends on (i.e. the sensors
we want to work at the outputs) called V1 and V2 (variables
1 and 2 in Fig. 3).
• It is possible to set the actions that the program has to
perform on the accessories connected to the system in the
centre part of the screen: Power unit, dosing pumps, etc.
(see A1,A2,A3 in fig.3)
• At the bottom of the screen a maximum time (Max. Time)
To: 12.00
can be set, within which the program must finish and beyond
which the program will automatically be stopped, signaling
an anomaly. The amount of time and the measurement unit
expressed in hours (h), minutes (m) and seconds (s) can be
set using the ,keys.
To define the program's variables, press "Enter" on one of
the V1 and V2 variables to access the sensor programming
screen (see Example 1).
38 - 60