Program Link Settings - Aquatronica evolution ACQ110 Instruction Manual

Example 1 (for level and water leakage sensors only)
1
1) Indicates the sensor to define as a variable, selectable using the  keys.
2) Indicates the condition necessary for starting the program (read-only).
3) Indicates the reference value.
4)Indicates the program's minimum run time (expressed in seconds); the value entered using the
 keys must be lower than the value entered in the "Max. Time" field.
Example 2 (for all other sensors)
Variable 2
1
Density
3
Ref.
+ 0,5
1) Indicates the sensor to define as a variable, selectable using the  keys.
2) Indicates the condition necessary for starting the program (selectable using the  keys); the
following values can be used:
- Greater than the reference value (>) or greater than or equal to the reference value (>=)
- Less than the reference value (<) or less than or equal to the reference value (<=)
3) Indicates the type of reference to use, selectable using the  keys, from two possible op-
tions:
- Reference expressed as a fixed value
- Reference expressed as a modifiable curve; in this case press "Enter" on the /\/\/\/\ symbol to
access the curve and change it as needed.
4) Indicates the programmable hysteresis; this value will be positive or negative depending on
the entered condition.
39 - 60
XY Program Link Settings
Variable 1
Sump 1 level
Ref.
Minimum time:
>= 2
1024,5
4
IsACQ110C-0 (ENG) Rev.230708-0
=
LEV1
5 sec.
Variable 2
1
Density
3
Curve
+ 0,5
2
3
4
>= 2
/\/\/\/\
4