Insert - Aquatronica evolution ACQ110 Instruction Manual

Programs
Ref.
∆MIN:
0.3°C
Plugs
(Fig. 59)
Cooler
PU01 A B
PU01 A B
(Fig. 60)
IsACQ110C-0 (ENG) Rev.230708-0
Temperature Menu

Insert

In this section it is possible to choose a desired temperature
and set a minimum and maximum tolerance for temperature
variation.
To adjust the temperature, proceed as follows:
Main screen  Main Menu  Temperature  Programs 
Insert.
• Select a reference temperature with keys  and set the
value desired with keys .
27.0°C
• Set the "∆MIN" and "∆MAX" tolerance values, selecting
the desired field with keys  and modifying its value with
∆MAX:
keys .
0.5°C
• Select "Plugs" with keys  to choose which outputs will
operate when the temperature is higher or lower than the set
Confirm
values and then press "Enter".
• Select the output to be utilized with keys ; the selected
output will flash on both lines. By operating on the upper line
of the outputs, it is possible to program the devices that will
be activated/deactivated when the temperature rises above
the maximum value established (Ref. + ∆MAX).
The outputs of the upper line are set with key .
The example indicated in the figure (Fig. 60) shows the activa-
tion of the cooler on outlet "B". By pressing the key  once,
the outlet is highlighted and above it the thermometer sym-
bol appears. In order to deactivate an outlet (lights, heater,
etc.) the key  must be pressed a second time.
In this case, only the symbol of the thermometer appears over
the selected outlet.
C D E F
Operating on the lower line outputs, the user can program the
devices that will be activated/deactivated when the temperature
falls below the minimum value established (Ref. - ∆MIN).
C D E F
The outputs of the lower line are set with key .
The example indicated in the figure (Fig. 60) shows the ac-
tivation of the heater on outlet "E". The outlet is highlighted
and the thermometer symbol appears above it.
46 - 60