Program Functions And Accessories Settings - Aquatronica evolution ACQ110 Instruction Manual

Program Functions and Accessories Settings

After defining the variables, the program's functions may be defined (from 1 to 3).
To define the program's functions, press "Enter" on one of the three functions (A1, A2 and A3) to
access the function programming screen (see Example 3).
Example 3
1
2
1) Indicates the power unit for setting the program; using the  keys, the power unit may be
chosen from those connected to the Aquatronica system.
2) Indicates the outlet of the module to be programmed, selectable using the  keys.
3) Indicates the status (selectable using the  keys) that the chosen outlet must assume during
program execution.
In the examples shown, the soft replenishing pump was programmed, which will start (Function)
only if the level sensor is at LEV1 (Variable 1) and the density is greater than or equal to 1024.5
(Variable 2).
If for any reason one of the two variables does not return to the initial value within 30 seconds
(Max. Time), the program automatically stops, indicating an anomaly.
This is helpful when the replenishing tank is empty (the pump stops operating, thus avoiding dam-
ages) or the replenishing water is leaking from the sump, causing flooding.
For example, we could set up another XY program that controls the salt water replenishing pump
so that it starts (Function) only if the level sensor is at LEV1 (Variable 1) and the density is less
than 1024.5 (Variable 2).
With two XY programs working together, soft water or salt water replenishing can be totally au-
tomatic.
IsACQ110C-0 (ENG) Rev.230708-0
Function 1
Multioutlet 1
Soft Replenishing Pump
Status:
From: 08.00
V1: Sump Level
V2: Density
A1: Soft Replenishing
A2: Undefined
A3: Undefined
Max. time 30 s
ON
To: 12.00
3
40 - 60