Plug Selection
A
Neon
B
Pump
C
C
D
D
E
E
(Fig. 30)
Neon
Insert
(Fig. 31)
Neon
From 14:25
ON
0m
Mo Tu We Th Fr Sa Su
(Fig. 32)
Pump
From 10:30
ON
20m
Mo Tu We Th Fr
(Fig. 33)
30 - 60
Power Unit Menu
Program Timer
This menu lets you make all the settings allowing one or more
timed programs to be run; it is, in fact, possible to select the
start and end time, and the day of the week when the selected
output has to be enabled.
To set a timer program, proceed as follows:
Main screen Main Menu Power Unit Program Timer.
• Select the output to program with keys (Fig. 30)
and press "Enter".
Insert (Fig. 31)
Allows the user to insert one or more programs inside the
selected output.
To modify this option, proceed as follows:
Main screen Main Menu Power Unit Program Timer
Insert.
• Set the start time ("From") and end time ("To") at which
the output is enabled. Select the desired option with keys ,
while modifying the values with keys .
• Set the "ON" and "OFF" (0÷600 minutes) values that allow
you to get repetitive on and off based on the times set within
the time frame set above; select the desired option with the
keys, whereas you can change the value with the keys.
• Set the days of the week in which the output is enabled.
Select the day with keys while with keys render it
To 19:25
active or non-active.
When all settings are complete, press "Enter".
OFF
0m
Example 1
In the example shown in the figure (Fig. 32) a program (Neon)
has been created where the neon turns on at 14.25 and turns
off at 19.25 every day of the week.
Example 2
In the example shown in the figure (Fig. 33), programming
(Pump) for which the pump turns on for 20 minutes and turns
off for 40 minutes repetitively starting at 10:30 and running
To 18:30
until 18:30 every day except Saturday was made.
OFF
40m
Su
IsACQ110C-0 (ENG) Rev.230708-0