Memory Function; Recording A Measurement - AEMC 6550 User Manual

5.1 Recording a Measurement

Each insulation measurement can be recorded once the measurement process is completed. It is not possible
to record input voltage measurements prior to starting a test.
The results are recorded at addresses identified by an object number (OBJ) and a test number (TEST).
An object can contain 99 tests. An object can represent a machine or an installation on which a certain number
of measurements will be performed.
■
At the end of the measurement, press the MEM button.
■
The instrument proposes recording the result at the first available location in memory. It is possible to
modify the proposed location using the ◄ ► and▲▼ arrow buttons.
■
Press the MEM button again to confirm the storage location.
■
The instrument then asks you if you want to Store Samples with the measurement.
The graph of the measurement can then be displayed by a single press on the GRAPH button (see § 2.4.5).
If this is not required, set Store Samples to OFF.
If Store Samples are set to Yes, the Sample Time can be set using the ◄ ► and▲▼ arrow buttons.
■ The default sampling time (the time difference between two stored samples) is the minimum, meaning that
all samples acquired during the measurement are recorded.
■ The sampling time can be set to Auto (automatic), in which case the instrument itself determines the
samples necessary for the plotting of the measurements while using the least possible memory. If the
Megohmmeter Models 6550/6555
Shop for AEMC products online at:

5. MEMORY FUNCTION

Store
Obj. Test
01 01
MEM
Store
Obj. Test
01 01
Store Samples
Sample Time (m:s)
MEM
ShopAEMC
www.
MEMORY
Date Time Fct.
2011-05-26 09:04 500V
MEMORY
Date Time Fct.
2011-05-26 09:04 500V
Min.
.ca 1.877.766.5412
Yes
43