Password Protection Setting - Mitsubishi Electric ME96SSRA-MB User Manual

5. Operation
5.2 Usage According to Purpose (Alarm, Periodic Active Energy, Rolling Demand, Operating
Time, Password, etc.)
 Password protection setting
In the operation mode, after pressing
display will be displayed. It is possible to set the password protection if you enter the password. Default password is
"0000". If you enter the wrong password, to return to the password input display (the highest digit blink).
By pressing at the highest digit, to return to the operation mode.
DISPLAY
If you enable password protection setting, you need to input password when performing the item of the following table.
■Password input
・ Select a value of the blinking digit by pressing
the
・ Pressing the
Password input display
(blinking digit) to a lower digit.
・
Pressing the
digit (blinking digit) to a higher digit.
・ If you enter a correct password and pressing
the
item is enabled.
・ If you enter an incorrect password and pressing
the
highest digit.

■Password protection setting

(1)Set a password protection.
oFF
（Not protected）
(2)Change the password.
no
（Not change）
Note1．Select "no", and go back to the operation mode.
Note2．Select "yES", and the current password is displayed.
(3)Input a new password.
・ Select a value of the blinking digit by pressing the
from the highest digit.
・ Pressing the
SET button moves the setting digit (blinking digit) to a
lower digit.
・ Pressing the
DISPLAY
to a higher digit.
・ Pressing the
button at the lowest digit saves the password.
SET
・Setting is available in range from 0000 to 9999
If You Forget Your Password：It is not possible to cancel the password in the field.
Important
Please contact your supplier.
RESET
and
or button from the highest digit.
－
＋
button moves the setting digit
SET
button moves the setting
DISPLAY
in the lowest digit, password protection
SET
in the lowest digit, to return to the
SET
on
（Protected）
yES
（Change）
or
＋
button moves the setting digit (blinking digit)
PHASE
simultaneously for 2 seconds or more, the password input
■Password protection item
No.
1 Shift to the setting mode
2 Clear the maximum/minimum value
3 Wh and varh, etc zero reset
4 Periodic
5 Adjusting rolling demand time
6 Resetting the peak value of rolling demand
7 Clearing the operation time
SET
SET
button
－
76
Item
Wh zero reset