Setting Menu 5: Pulse And Alarm Settings (Setting Upper/Lower Limit Alarm, Motor Starting Current Mask Function, Pulse Output, Etc.) - Mitsubishi Electric ME96SSRA-MB User Manual

3. Setting
3.8. Setting Menu 5:
This section shows how to set the upper/lower limit alarm, backlight flickering during alarm, motor starting current delay time, and
pulse output.
In the operation mode, press
For more details about each function, refer to the corresponding pages.
Upper/lower limit alarm → Pages 71 and 72, Motor startup current → Page 75
Setting menu
DISPLAY SET
①
Alarm item 1
DISPLAY SET
Pulse and Alarm Settings (Setting Upper/Lower Limit Alarm, Motor
Starting Current Mask Function, Pulse Output, etc.)
and simultaneously for 2 seconds or more, and the following operation becomes available.
SET RESET
Set the setting menu number to "5".
(as shown in the right figure)
Set the Alarm item 1 to be allowed to measurement items.
The upper/lower limit measurement values can be monitored by this setting.
(1) For 3-phase 4-wire
non
A upper limit
A lower limit
AN upper limit
DA upper limit
DA lower limit
DAN upper limit
V (L-N) upper limit
V (L-N) lower limit
V (L-L) upper limit
V (L-L) lower limit
W upper limit
W lower limit
(2) For other phase wire system except 3-phase 4-wire
non
A upper limit
A lower limit
DA upper limit
DA lower limit
V upper limit
V lower limit
W upper limit
W lower limit
Note 1. Measurement items that are not selected in the display pattern can be selected.
Note 2. DA: Current demand, DAN: N-phase current demand,
V (L-N): Phase to neutral voltage, V (L-L): phase to phase voltage,
DW: Active power rolling demand, Dvar: Reactive power rolling demand,
DVA: Apparent power rolling demand
DW upper limit
var upper limit
var lower limit
Dvar upper limit
DVA upper limit
PF upper limit
PF lower limit
Hz upper limit
Hz lower limit
Harmonic current total RMS Value
N-phase harmonic current total RMS value
Harmonic voltage total distortion ratio
DW upper limit
var upper limit
var lower limit
Dvar upper limit
DVA upper limit
PF upper limit
PF lower limit
Hz upper limit
Hz lower limit
Harmonic current total RMS value
Harmonic voltage total distortion ratio
34
Display when "non"
is selected
Display when
"A upper limit" is
selected