Mitsubishi Electric ME96SSRA-MB User Manual page 13

1. Display and Button Functions of Each Parts
Display
No.
Segment Name
1 LEAD status
2 LAG status
3 Scale of the bar graph
4 Under scale input
5 Over scale input
6 Index indicator
7 Bar graph status
8 Phase status
9 Digital display
10 Unit
11 Metering status
12 Harmonics
13 Setup status
14 Test mode status
15 Clock status
Upper/lower limit alarm
16
status
Communication or Logging
17
status
Note 1. The blinking cycle is constant regardless of the size of the measured input.
3
4
7
8
9
13 14 15
Note: The above display is an example for explanation.
They show direction of Power Factor or Reactive Power on bar graph.
They show the type of counting of Reactive Energy on Reactive Energy Display.
They show the scales of the bar graph.
Turns on when measuring values fall below the minimum scale.
Turns on when measuring values exceed the maximum scale.
When upper/lower limit alarm set, flickers at the limit setting value.
They show the item expressed with the bar graph.
When the item is the same as a digital displayed item, indicated
otherwise indicated
They show the phase for each of the digital displays.
Measured values displayed in digital.
Units of measuring value displayed.
Flickers when counting active energy.(Note.1)(only active energy imported display)
Turns on when harmonics displayed.
Turns on at setting mode. (
Flickers at setting value confirmation mode. (
Turns on at the test mode.
Turns on when
Flickers when upper/lower limit alarm is generated.
Specification
CC-Link communication
®
MODBUS RTU communication
®
MODBUS TCP communication
Logging function
*1. For details, refer to Section 6.6.(page86).
1 2
16 17 12
Description
」
with「
)
Operation time displayed.
On
Normal
Normal
Normal
12
3
5
6
10
11
with「 」,
)
Blinking
CC-Link version mismatch
Hardware error
Communication error
(Such as wrong address)*1
Error such as incorrect
setting, SD memory card
error, low battery voltage)*1
Off
Hardware error
Hardware error
Hardware error