Setting Menu 5: Alarm Settings (Setting Upper/Lower Limit Alarm, Motor Starting Current Mask Function, Etc.) - Mitsubishi Electric ME96SSEA-MB User Manual

3. Setting
3.6. Setting Menu 5:
This section shows how to set the upper/lower limit alarm, backlight flickering during alarm and, motor starting current delay time.
In the operation mode, press
For more details about each function, refer to the corresponding pages.
Upper/lower limit alarm → Pages 44 and 45, Motor startup current → Page 46
①
Alarm item 1
DISPLAY
Alarm Settings (Setting Upper/Lower Limit Alarm, Motor Starting
Current Mask Function, etc.)
and simultaneously for 2 seconds or more, and the following operation becomes available.
Set the Alarm item 1 to be allowed to measurement items.
The upper/lower limit measurement values can be monitored by this setting.
(1)
For 3-phase 4-wire
non
A upper limit
A lower limit
AN upper limit
DA upper limit
DA lower limit
DAN upper limit
V (L-N) upper limit
V (L-N) lower limit
V (L-L) upper limit
V (L-L) lower limit
W upper limit
W lower limit
(2)
For other phase wire system except 3-phase 4-wire
non
A upper limit
A lower limit
DA upper limit
DA lower limit
V upper limit
V lower limit
W upper limit
W lower limit
Note 1. Measurement items that are not selected in the display pattern can be selected.
Note 2. DA: Current demand, DAN: N-phase current demand,
V (L-N): Phase to neutral voltage, V (L-L): phase to phase voltage,
PF upper limit
PF lower limit
Hz upper limit
Hz lower limit
Harmonic current total RMS Value
N-phase harmonic current total RMS value
Harmonic voltage total distortion ratio
PF upper limit
PF lower limit
Hz upper limit
Hz lower limit
Harmonic current total RMS value
Harmonic voltage total distortion ratio
24
Display when "non"
is selected
Display when
"A upper limit" is
selected