Quick Setup Menu - Printronix T5000e Series Quick Setup Manual

Chapter 2

QUICK SETUP Menu

QUICK SETUP Menu
QUICK SETUP
Print Intensity
-3*
Print Speed
6 ips*
Print Mode
Transfer*
Media Handling
Tear-Off Strip*
Paper Feed Shift
0.00 inches*
Label Length
4 or 6 inches*
Label Width
4.1, 6.6, or 8.5 inches*
Ver Image Shift
0.00 inches*
Hor Image Shift
0.00 inches*
Orientation
Portrait*
Gap/Mark Sensor
Disable*
Auto Calibrate
Run Calibrate
Save Config.
Power-Up Config.
Factory*
(cont. on next page)
38
-15 to 15
1
2-10 ips
Direct
Tear-Off
2
-0.50 to X inches
2, 4
00.1 to 99.0 inches
2, 4
00.1 to 8.5 inches
2
-1.00 to X inches
2
-1.00 to 1.00 inches
Landscape
Mark Gap
Notes:
* = Default
1* 1-8
1
Maximum value depends on the width of the
printer model and printhead.
1-8
2
You can change the unit value from inches to
millimeters under Units (in MEDIA CONTROL)
Refer to the User's Manual for information.
3
Based on the current value setting for the Label
Length menu, up to a maximum of 12.80 inches.
4
Maximum value depends on the width of the
printer model.
5
Maximum value depends on model width and size
of DRAM installed.
Peel-Off Cut Continuous
3
5
4
3
Inv. Portrait Inv. Landscape
Advanced Gap Advanced Notch