Oracle SPARC T7-2 Installation Manual page 60

Reach a State to Install a Fresh OS (Oracle ILOM CLI)
-> reset /System
Are you sure you want to reset /System (y/n)? y
Performing reset on /System
Note -
the legacy name in a command at any time, but to expose the legacy name in the output, you
must enable it with ->
Oracle ILOM 3.1 documentation.
4. Switch communication to the server host.
-> start /HOST/console
Are you sure you want to start /HOST/console (y/n)? y
Serial console started. To stop, type #.
The server might take several minutes to complete POST, and then the OpenBoot prompt (ok) is
displayed.
5. Boot from the appropriate boot media for your installation method.
For more information, refer to the Oracle Solaris installation guide that corresponds to your
desired release and installation method.
Installing Oracle Solaris 11 Systems, comparing installation options at:
■
http://www.oracle.com/goto/solaris11/docs
Oracle Solaris 10 Installation Guide: Planning for Installation and Upgrade, choosing an
■
Oracle Solaris installation method at:
http://www.oracle.com/goto/solaris10/docs
For a list of valid boot commands that you can enter at the OpenBoot prompt, type:
{0} ok help boot
boot <specifier> ( -- )
Examples:
boot
boot net
boot cdrom
boot disk1:h
boot tape
boot disk myunix -as
dload <filename> ( addr -- )
Examples:
4000 dload /export/root/foo/test
?go - if executable program, execute it
or if Forth program, compile it
60 SPARC T7-2 Server Installation Guide • March 2016
In Oracle ILOM 3.1, the name space for /SYS was replaced with /System. You can use
set /SP/cli legacy_targets=enabled
boot kernel ( default ) or other file
- boot kernel from default device.
Factory default is to boot
from DISK if present, otherwise from NET.
- boot kernel from network
- boot kernel from CD-ROM
- boot from disk1 partition h
- boot default file from tape
- boot myunix from disk with flags "-as"
debug load of file over network at address
. For more information, see the