FujiFilm SonoSite Edge User Manual Supplement page 15

8 Verify that all gel, debris, and bodily fluids have been removed from the system and transducer. If
necessary, repeat steps 5, 6, and 7 with a new wipe.
WARNING
9 Examine the system, transducer, and cable for damage, such as cracks or splitting where fluid can enter.
If damage is evident, discontinue use, and contact FUJIFILM SonoSite or your local representative.
10 Prepare the disinfectant for use.
a Choose a high-level disinfectant from the list of approved disinfectants.
High-level disinfectants compatible with SonoSite Edge, SonoSite M-Turbo, and SonoSite S Series
transducers
Disinfectant Compatible transducers
Cidex C11x, C60x. C60xi, C8x, HFL38x,
HFL50x, ICTx, L25x, L38x, L38xi,
P10x, P21x, P11x
Cidex OPA C11x, C60x. C60xi, C8x, HFL38x,
HFL50x, ICTx, L25x, L38x, L38xi,
L52x, P10x, P21x
For a more complete list, refer to the cleaners and disinfection document available at www.sonosite.com.
b Check the expiration date on the bottle to ensure the disinfectant has not expired.
c Mix or check that the disinfection chemicals have the concentration recommended by the manufacturer
(for example, a chemical strip test).
d Check that the temperature of the disinfectant is within the manufacturer's recommended limits.
11 Perform a high-level disinfection of the transducer. Use the following procedure:
a Immerse the transducer in a high-level disinfectant solution.
WARNING
Cleaning and disinfecting
Failure to remove all gel, debris, and bodily fluid could leave contaminants on
the probe.
High-level disinfectants can cause harm to the patient if not completely
removed from the transducer. Follow the manufacturer's rinse instructions to
remove chemical residue.
Disinfectant Soak Duration
Temperature
25 °C (77 °F) 45 minutes
20 °C (68 °F) 12 minutes
13