changes the value to 1 (p-t w/Logoff). ("p-t w/Logoff" stands for "pass-thru with Logoff".) If
the current value is Supplicant mode (2), pressing * changes the value to 0 (pass-thru).
If a value different from the current 802.1X value is entered, the following text displays
left-justified at the top of the display:
Save new value?
*=no
2. Press the * button to terminate the procedure, or the # button to save the new value. If you
press the # button, the deskphone displays the following text:
New value being saved
The deskphone saves the new value.
Change the DOT1XSTAT Mode Value
Use the following procedure to change the DOT1XSTAT mode value.
1. Press #.
The following text displays:
Supplicant=setting
*=change #=OK
where the setting is the current value of the system value DOT1XSTAT (802.1X Supplicant
Mode), defined as:
●
●
●
2. To change the mode value, press *.
Depending on the current value, the next sequential valid mode value is selected and
displayed as the setting. For example, if the current value is Disabled (0), pressing *
changes the value to 1 (Unicast only). If the current value is Unicast/multicast mode (2),
pressing * changes the value to 0 (Disabled).
If a value different from the current 802.1X value is entered, the following text displays
left-justified at the top of the display:
Save new value?
*=no
http://ArtTel.ru
#=yes
Disabled if setting = 0
Unicast only if setting = 1
Unicast/multicast if setting = 2
#=yes
Set the 802.1X Operational Mode
Issue 5 April 2014
33