Dynamic Addressing Process - Avaya 1600 Series Installation And Maintenance Manual

1600 Series IP Deskphone Installation
1. Plug one end of the first Cat5e Ethernet cable into the Ethernet jack of the PC and the other
end into the secondary Ethernet jack on the 1600 Series IP Deskphone,
if appropriate.
2. Plug one end of the second Cat5e Ethernet cable into the Ethernet jack on the 1600 Series
IP Deskphone. Plug the other end of this cord into the Ethernet wall jack. If the deskphone
is to be IEEE-powered, you are finished. Do not proceed to Step 3.
3. If the deskphone is to be powered locally, plug the power cord into the 1600 Series IP
Deskphone and the power cord plug into the wall socket.

Dynamic Addressing Process

Note:
Note:
The following description of the process of installing the IP deskphones assumes that the
process is executed successfully. Only an initial out of the box installation is described. For
errors that might be encountered during the process and the messages displayed, see
Chapter 5: Troubleshooting
When you plug the IP deskphone set into the Ethernet wall jack and apply power, if applicable,
the following process takes place.
Note:
Note:
1. The deskphone activates the Ethernet line interface, the PC Ethernet jack, and dial pad
input
to allow the invocation of procedures. The activation occurs as soon as possible after
power-up or a reset.
The deskphone displays the speed of the Ethernet interface in Mbps, that is,
10 or 100. The message No Ethernet displays until the software determines whether the
interface is 10 Mbps or 100 Mbps.
24 1600 Series IP Telephone Installation and Maintenance Guide
http://ArtTel.ru
Before starting this process you must have an extension number for the IP
deskphone and the Avaya Aura Communication Manager security code
(password) for that extension, unless the deskphone will use unnamed
registration. For more information, see
Any reference to the HTTP server applies equally to an HTTPS server.
Guidelines.
If the application has already been downloaded, the whole process takes
approximately 1 to 2 minutes after the deskphone is plugged in. For software
upgrades, including the boot file and application file download, the process might
take 5 - 10 minutes. The duration is based on LAN loading, how many
deskphones are being installed at once, and similar factors.
Do not unplug the power cord during the download process.
Unnamed Registration on page 27.