Avaya 1600 Series Installation And Maintenance Manual page 25

Note:
Note:
2. The IP deskphone sends a request to the DHCP server and invokes the DHCP process.
One of the following messages display:
DHCP: s secs
* to program
where s is the number of seconds that have elapsed since DHCP was invoked. The
message on the left appears if 802.1Q tagging is off and access to local programming
procedures is not disabled or restricted. (See
specifics.) The middle message appears if 802.1Q tagging is on and access to local
programming procedures is disabled or restricted. If the left and middle messages alternate
every two seconds, 802.1Q tagging is on. When both messages alternate, access to local
programming procedures is not disabled or restricted. Finally, the message on the right
appears if 802.1Q tagging is off and access to local programming procedures is disabled or
restricted.
3. The DHCP server provides IP addresses for the following hardware:
●
●
●
4. Using the list of gateway IP addresses provided by the DHCP server, the deskphone
performs a router check. The deskphone cycles through the gateway IP addresses with
ARPs or pings until it receives a response. When the router is located, the HTTP/HTTPS
process starts.
5. While the IP deskphone connects to the HTTP/HTTPS server, the deskphone displays the
following message:
HTTP:n ipadd
where n is the number of the IP address obtained from the HTTP/HTTPS server and ipadd
is the IP address.
6. When connected, the deskphone looks for an upgrade script file.
http://ArtTel.ru
The Ethernet speed indicated is the LAN interface speed for both the deskphone
and any attached PC, assuming the administrator has not disabled the latter
interface by a PHY2STAT setting.
The IP deskphone
The HTTP/HTTPS server
The TN799C or D Control-LAN (CLAN) circuit pack on the media server
DHCP: s secs
VLAN ID = n
Chapter 3: Local Administrative Options
Dynamic Addressing Process
DHCP: s secs
Issue 5 April 2014
for
25