Printing Your First Creation; Wi-Fi Connection - 3D Systems Cube 2nd Generation User Manual

22

PRINTING YOUR FIRST CREATION

WARNING
TION. DO NOT TOUCH NOZZLE.
Do not change color of material or cartridge during printing; doing so may damage the
Cube.
NOTE: Your Cube will have printed test creations before leaving the factory. These test creations
may have been printed in a different material color than you are using. Therefore, a small amount
of material may be remaining in the print jet. The start of your first creation may have some of this
material color until it transitions over to your material color.
To get started printing your first creation; the creation files that were downloaded when you activated your account or a
.STL file will need to be converted to a .Cube file. This is the machine code file that the Cube printer will read to build your
creation.
WI-FI Connection: if you wished to connect to WI-FI via Ad hoc or WPS connection, please refer to Section 12, WI-FI
Set-Up and follow the step by step instructions. Then resume these instructions and follow the steps below to connect to
your Cube. These steps apply to both Ad Hoc and WPS connections.
1. Open Cubify Software and click on "Configure." Click on your Cube model in the dialog box and click on
"Connected. Your computer is now connected to your Cube.
42
–PRINTJET NOZZLE TIP BECOMES EXTREMELY HOT DURING SET-UP AND OPERA-
Click here
second
Click here
third
Click here first