Adjusting The Back Support Upholstery / Seat Upholstery; Adapting The Adjustable Back Support Upholstery; Adjusting The "Ultralight" Back Support Upholstery; Adjusting The Seat Upholstery - Otto Bock Zenit Instructions For Use Manual

Settings
37

6.6 Adjusting the back support upholstery / seat upholstery

INFORMATION
The adjustments described below may also be carried out the same way on the CLT model (not illustrated).

6.6.1 Adapting the adjustable back support upholstery

INFORMATION
A well-adjusted back support provides lasting comfort for the wheelchair user and reduces the risk of secondary
damage and pressure zones.
INFORMATION
Ensure that the user's pelvis is positioned as far back in the wheelchair as possible, i.e. between the back sup­
port tubes.
The back support upholstery can be adapted in segments to the needs of the user.
1) Remove the back support pad.
2) Loosen the hook-and-loop fastener of the upholstery straps (see fig. 38, item 1).
3) Fasten the upholstery straps with the desired tension using the hook-and-loop fastener.
If necessary, unthread/thread the upholstery straps from/through the flaps to do so (see fig. 39, item 1).
4) If the upholstery straps are too long, they can be shortened. To do so, remove the end pieces from the uphol­
stery straps (see fig. 39, item 2), trim the upholstery straps and reinstall the end pieces.
5) Put on the back support pad and attach it with the hook-and-loop fastener.
38

6.6.2 Adjusting the "ultralight" back support upholstery

The back upholstery tension cannot be adjusted with this wheelchair type.

6.6.3 Adjusting the seat upholstery

"Ultralight" seat upholstery
There are no adjustment possibilities for the "ultralight" seat upholstery.
20
39
Zenit