Machine Safety Regulations; 1-1) Machine Transportation; 1-2) Machine Installation; 1-3) Machine Repair - SunStar SPS/E-BS1201H User Manual

1 1

Machine Safety Regulations

Safety instruction on this manual are defined as Danger, Warning and Caution.
If you do not keep the instructions, physical injury on the human body and machine damage might be occurred.
Caution
: When the machine is improperly handled, user injury or physical damage to the machine is expected to occur.
Warning
: When the machine is improperly handled, critical injury or death of a user is expected to occur.
Danger
: When the machine is improperly handled, critical injury or death of a user is expected to occur, and the high-level
of emergency situation would like to happen.
1-1) Machine
Transportation
Danger
1-2) Machine
Installation
Caution

1-3) Machine Repair

Danger
6
Those in charge of transporting the machine should know the safety regulations very well.
The following indications should be followed when the machine is being transported.
ⓐ More than 2 people must transport the machine.
ⓑ To prevent accidents from occurring during transportation, wipe off the oil on the machine
well.
The machine may not work well or breakdown if installed in certain places. Install the
machine where the following qualifications agree.
ⓐ Remove the package and wrappings starting from the top. Take special notice on the nails
on the wooden boxes.
ⓑ Dust and moisture stains and rusts the machine. Install an airconditioner and clean the
machine regularly.
ⓒ Keep the machine out of the sun. If the machine is exposed in direct ray of light for a long
time, transformation of color and shape can be happened.
ⓓ Leave sufficient space of more than 50cm behind, and on the right, left and back side of
the machine for repairing.
ⓔ Do not operate in explosive atmospheres. To avoid explosion, do not operate this machine in
an explosive atmosphere including a place where large quantities of aerosol spray product
are being used or where oxygen is being administered unless it has been specifically
certified for such operation.
ⓕ The machine were not provided with alocal lighting due to the feature of machine.
Therefore the illumination of the working area must be fulfilled by end user.
[Refer] Details for machine installment are described in 4. Machine Installment.
When the machine needs to be repaired, only the assigned troubleshooting engineer educated
at the company should take charge.
ⓐ Before cleaning or repairing the machine, close down the motive power and wait 5
minutes till the machine is completely out of power.
ⓑ Not any of the machine specifications or parts should be changed without consulting the
company. Such changes may make the operation dangerous.
ⓒ Spare parts produced by the company should only be used for replacements.
ⓓ Put all the safety covers back on after the machine has been repaired.