4-3) Checking Pattern Shape; 4-4) Sewing - SunStar SPS/E-BS1201H User Manual

4-3) Checking Pattern Shape

1) Make sure to check the pattern shape after selecting pattern number.
1) If pattern goes beyond the driving limit of the presser plate, needle and presser plate may
conflict during sewing and result in serious problems, i.e. needle break.
Caution
2) Do NOT pedal 2nd step while checking the pattern shape. 2nd step pedaling starts sewing.

4-4) Sewing

■ 2-step pedal switch interconnection
1st step pedaling: clamp function
16
1st Step
2nd Step
1st step pedal switch
2nd step pedal switch
1) In READY status, press pedal 1st step to bring down the
presser plate.
2) The presser plate moves by one stitch at every press of
+/FORWARD or –/BACK
move the plate continuously.
3) Press to move the needle to the starting point.
RESET
The presser plate will move up.
◀ CAUTION ▶
Take your foot off the pedal when the needle starts to
move (even a stitch).
1) Place the work material on the presser plate.
2) Pedal 1st step to bring down the presser plate. Take your
foot off the pedal to lift the plate.
3) Pedal 2nd step with the presser plate down and the
sewing will start.
4) When the sewing is completed, presser plate will go up
and move to the sewing starting point.
2nd step pedaling: sewing starts
. Press down the keys to