SunStar SPS/E-BS1201H User Manual page 38

(3) Using Scalable Pattern ROM
① Installing Scalable Pattern ROM
1) Take the cover off the Bartack control box.
2) As shown in the previous page, install the scalable design ROM onto the "U9" location on the digital board. Make
sure to align the direction with the indication on the board (so the direction mark is on the left). Pin should go into
the socket accurately.
② Using Scalable Pattern
1) If the pattern number is set up by default as call impossible, change the set-up of the
2) Check the pattern shape and confirm that the needle and the presser plate do not conflict.
Caution
(for BS(BR)1201 series)
Ex) Changing the scalable pattern No.33 and No.34 to call possible
A. Turn on the power, pressing
Press and then
A
B. Press
READY
ⓐ part : pattern number, ⓑ part : 0 : call impossible, 1 : call possible
C. Press
SELECT
D. Press
+/FORWARD
E. Press
SELECT
F. Press
+/FORWARD
G. Press
READY
H. Turn off the power and back on again. Select your desired number.
38
pattern to call possible.
READY
to display "A-03" on the screen.
+/FORWARD
to display the present set-up value.
to change ⓐ "1" to "33".
to change ⓑ "0" to "1".
to change ⓐ "33" to "34".
to change ⓑ "0" to "1".
to register.
and RESET at the same time.
A - 0 3
0 1 - 1
ⓐ ⓑ
3 3 - 0
3 3 - 1
3 4 - 0
3 4 - 1
A - 0 3