SunStar SPS/E-BS1201H User Manual page 40

(4) Using Hole Fixing Device
■ SUB machine type
Direct connection type: SPS/E-BS(BR)1201M(HP)
■ Parameter changes and default values for using electronic wiper and hole fixing device
Parameter
Group No.
A-18
A-23
A-27
A-30
A-34
1) Electronic wiper cannot be used with the hole-fixing device.
2) Initializing to the hole-fixing device version will look like the above table. To use the patterns in
the scalable ROM, you must set YES/NO for the pattern data calling possibility as shown below.
3) For SPS/E-BS1201M(HP) or SPS/E-BR1201M(HP), exclusive scalable pattern is provided.
Caution
(No.33 ~ No. 92 )
■ How to Use
First set the possibility/impossibility of the pattern data call
Ex) Changing exclusive scalable pattern No.33-92 to call possible
A. Turn on the power, pressing
Press A and then
B. Press READY
ⓐ part : pattern number, ⓑ part : 0 : call impossible, 1 : call possible
C. Press
SELECT
D. Press
+/FORWARD
E. Repeat C and D steps to get ⓐ "91"
F. Press
SELECT
G. Press
+/FORWARD
H. Press
READY
I. Turn off the power and back on again. Select your desired number
If pin hole cannot come up or go down, Er11 will occur. Turn OFF the power, fix the problem
and turn on the power again.
Caution
40
Electronic wiper
Content
Electronic wiper ON time
Electronic wiper full ON time
Electronic wiper duty value
Electronic wiper OFF time
Pin attach use Yes/No
( 0: NO 1: YES)
and
READY
to display "A-03" on the screen.
+/FORWARD
to display the present set-up value.
to change ⓐ "1" to "33".
to change ⓑ "0" to "1".
to change ⓐ "91" to "92"
to change ⓑ "0" to "1".
to register.
Default
100[ms] Pin attach descending time
100[ms] Pin solenoid full ON time
20[%] Pin solenoid duty value
40[ms] Pin attach ascending time
Pin attach use Yes/No
0
at the same time.
RESET
Hole fixing device
Content
( 0: NO 1: YES)
A - 0 3
ⓐ
0 1 - 1
3 3 - 0
3 3 - 1
9 1 - 0
9 2 - 0
9 2 - 1
A - 0 3
default
100[ms]
100[ms]
20[%]
100[ms]
1
ⓑ