Machine Safety Regulations; Transporting Machine; Installing Machine; Repairing Machine - SunStar KM-1957-7 User Manual

1 1

Machine safety regulations

Safety instructions on this manual are defined as Danger, Warning and Notice.
If you do not follow the instructoins, physical injuries and machine damages might be occurred.
: This indication should be observed definitely. If not, there will be a danger during the installation,
Danger
conveyance and maintenance of the machine.
Warning : When you follow this indication, injuries from the machine can be prevented.
: When you follow this indication, error on the machine can be prevented.
Notice
1-1) Transporting
machine
Danger
1-2) Installing
machine
Warning
1-3) Repairing
machine
Notice
6
Those in charge of transporting the machine should have a full understanding of the
machine. The following indications should be followed when the machine is being
transported.
ⓐ More than 2 people must transport the machine.
ⓑ To prevent accidents from occurring during transportation, wipe off the oil
on the machine compeletely.
The machine may not work properly or breakdown, if installed in certain places, Install the
machine where the following qualifications agree.
ⓐ Remove the package and wrappings from the top. Take special
notice on the nails on the wooden boxes.
ⓑ Dust and moisture stains and rusts the machine. Install an airconditioner
and clean the machine regularly.
ⓒ Keep the machine out of the sun.
ⓓ Leave sufficient space of more than 50cm behind, and on the right and left
side of the machine for repairing.
ⓔ EXPLOSION HAZARDS
Do not operate in explosive atmospheres. To avoid explosion, do not operate
this machine in an explosive atomsphere including a place where large
quantities of aerosol spray product are being used or where oxygen is being
administered unless it has been specifically certified for such operation.
ⓕ The machine is not provided with a local lighting due to the feature of
machine.
Therefore the illumination of the working area must be fulfilled by end user.
[Refer] Details for machine installation are described in 4. Installation.
When the machine needs to be repaired, only the assigned troubleshooting engineer
educated at the company should take charge.
ⓐ Before cleaning or repairing the machine, turn off the main power
and wait 4 minutes till the machine is completely out of power.
ⓑ Not any of the machine specifications or parts should be changed
without consulting the company.
Such changes may make the operation dangerous.
ⓒ Spare parts produced by the company should only be used for
replacements.
ⓓ Put all the safety covers back on the machine after the machine has been repaired.