Global Program Settings (Software Option) - HEIDENHAIN iTNC 530 User Manual

Hide thumbs Also See for iTNC 530:

Table of Contents

11.5 Global Program Settings

(Software Option)

The global program settings, which are used in particular for large

molds and dies, are available in the Program Run mode and MDI

mode. You can use them to define various coordinate transformations

and settings that are globally effective and are superimposed on the

respectively selected NC program so that you do not need to edit the

You can activate and deactivate global program settings, even in mid-

program if you have interrupted the program run (see "Interrupting

machining" on page 547). The TNC immediately accounts for the

values you have defined after you have restarted the NC program. The

control might move to the new position over the reapproach menu

(see "Returning to the contour" on page 554).

The following global program settings are available:

Definition of a handwheel

superimposition, even in the virtual axis

direction VT

Definition of a globally effective feed rate

HEIDENHAIN iTNC 530

Show Quick Links

Chapters

Table of Contents