HEIDENHAIN iTNC 530 User Manual page 609

TNC displays, TNC editor
Select the "Program
Run" mode of
operation: Display of
multi-tiered NC blocks
Position display in the
tool axis
Display step for the
spindle position
Display step
Disable datum setting
in the preset table
HEIDENHAIN iTNC 530
MP7281.1
Always show all NC blocks completely: 0
Only show current block completely: 1
Only show NC block completely when editing: 2
MP7285
Display is referenced to the tool datum: 0
Display in the tool axis is referenced to the
tool face: 1
MP7289
0,1 °: 0
0,05 °: 1
0,01 °: 2
0,005 °: 3
0,001 °: 4
0,0005 °: 5
0,0001 °: 6
MP7290.0 (X axis) to MP7290.13 (14th axis)
0.1 mm: 0
0.05 mm: 1
0.01 mm: 2
0.005 mm: 3
0.001 mm: 4
0.0005 mm: 5
0.0001 mm: 6
MP7294
Do not disable datum setting: %00000000000000
Disable datum setting in the X axis: Bit 0 = 1
Disable datum setting in the Y axis: Bit 1 = 1
Disable datum setting in the Z axis: Bit 2 = 1
Disable datum setting in the IVth Disable axis: Bit 3 = 1
Disable datum setting in the Vth axis: Bit 4 = 1
Disable datum setting in the 6th axis: Bit 5 = 1
Disable datum setting in the 7th axis: Bit 6 = 1
Disable datum setting in the 8th axis: Bit 7 = 1
Disable datum setting in the 9th axis: Bit 8 = 1
Disable datum setting in the 10th axis: Bit 9 = 1
Disable datum setting in the 11th axis: Bit 10 = 1
Disable datum setting in the 12th axis: Bit 11 = 1
Disable datum setting in the 13th axis: Bit 12 = 1
Disable datum setting in the 14th axis: Bit 13 = 1
609