HEIDENHAIN iTNC 530 User Manual page 6

TNC Model, Software and Features
This manual describes functions and features provided by TNCs as of
the following NC software numbers.
TNC model
iTNC 530, HSCI and HeROS 5
iTNC 530, HSCI and HeROS 5
iTNC 530 Programming
Workstation, HeROS 5
The suffix E indicates the export version of the TNC. The export
versions of the TNC have the following limitations:
Simultaneous linear movement in up to 4 axes
HSCI (HEIDENHAIN Serial Controller Interface) identifies the new
hardware platform of the TNC controls.
HeROS 5 identifies the operating system of HSCI-based TNC controls.
The machine tool builder adapts the usable features of the TNC to his
machine by setting machine parameters. Some of the functions
described in this manual may therefore not be among the features
provided by the TNC on your machine tool.
TNC functions that may not be available on your machine include:
Tool measurement with the TT
Please contact your machine tool builder to become familiar with the
features of your machine.
6
NC software number
606 420-02
606 421-02
606 421-02