HEIDENHAIN iTNC 530 User Manual page 16

New Functions with 606 42x-02
New function for opening 3-D data (software option) directly on the
TNC (see "Open 3-D CAD data (software option)" page 255 ff)
Improvement of Dynamic Collision Monitoring (DCM):
The display of stepped tools has been improved
When you select tool carrier kinematics, the TNC now displays a
graphical preview of the carrier kinematics (see "Assigning the
tool-carrier kinematics" on page 180)
Extension of the functions for multiple axis machining:
In manual mode, you can now also travel the axes again when
TCPM and Tilt Machining Plane are active at the same time
You can now also change tools when M128/FUNCTION TCPM is active
File management: archiving of files in ZIP archives (see "Archive
files" page 130 ff)
The nesting depth for program calls has been increased from 6 to 10
(see "Nesting depth" on page 263)
There is now a search function based on tool names available in the
tool selection pop-up window (see "Search for tool names in the
selection window" on page 187)
Improvements in pallet machining:
The new column FIXTURE has been added to the pallet table to be
able to activate fixtures automatically (see "Pallet Operation with
Tool-Oriented Machining" page 446 ff)
The new workpiece status SKIP has been added to the pallet table
(see "Setting up the pallet level" page 452 ff)
If a tool sequence list is created for a pallet table, the TNC now
also checks that all the NC programs of the pallet table are
available (see "Calling tool management" on page 193)
The new host computer operation was introduced (see "Host
computer operation" on page 593)
The SELinux security software is available (see "SELinux security
software" on page 87)
16