HEIDENHAIN iTNC 530 User Manual page 14

In Manual mode the RW-3D mode for position display is now also
available (see "Position Display Types" on page 581)
Entries in the tool table TOOL.T (see "Tool table: Standard tool data"
on page 170)
New DR2TABLE column for definition of a compensation table for
tool radius compensation depending on the tool's contact angle
New LAST_USE column, into which the TNC enters the date and
time of the last tool call
Q parameter programming: QS string parameters can now also be
used for jump addresses of conditional jumps, subprograms or
program section repeats (see "Calling a subprogram", page 259, see
"Calling a program section repeat", page 260 and see "Programming
If-Then decisions", page 284)
The generation of tool usage lists in the Program Run modes can be
configured in a form (see "Settings for the tool usage test" on page
190)
The behavior during deletion of tools from the tool table can now be
influenced via machine parameter 7263 see "Editing tool tables",
page 177
In the positioning mode TURN of the PLANE function you can now
define a clearance height to which the tool is to be retracted before
tilting to tool axis direction (see "Automatic positioning:
MOVE/TURN/STAY (entry is mandatory)" on page 422)
The following additional functions are now available in the expanded
tool management (see "Tool management (software option)" on
page 193):
Columns with special functions are also editable now
The form view of the tool data can now be exited with or without
saving changed values
The table view now offers a search function
Indexed tools are now shown correctly in the form view
The tool sequence list includes more detailed information now
The loading and unloading list of the tool magazine can now be
loaded and unloaded by drag and drop
Columns in the table view can be moved simply by drag and drop
Several special functions (SPEC FCT) are now available in the MDI
operating mode (see "Programming and Executing Simple
Machining Operations" on page 522)
There is a new manual probing cycle that can be used to
compensate workpiece misalignments by rotating the rotary table
(see "Workpiece alignment using 2 points" on page 504)
New touch probe cycle for calibrating a touch probe by means of a
calibration sphere (see User's Manual for Cycle Programming)
14