HEIDENHAIN iTNC 530 User Manual page 13

New functions 606 42x-01 since the
predecessor versions 340 49x-05
Opening and Editing of externally created files is new (see
"Additional tools for management of external file types" on page
132)
New functions in the task bar added (see "Soft-key row" on page
86)
Enhanced functions for configuration of the Ethernet interface (see
"Configuring the TNC" on page 569)
Improvements regarding Functional Safety FS (option):
General information on Functional Safety FS (see "General
Information" on page 478)
Explanation of terms (see "Explanation of terms" on page 479)
Checking the axis positions (see "Check axis positions" on page
480)
Activating feed-rate limitation (see "Activating feed-rate
limitation" on page 482)
Improvements regarding the general status view of a TNC with
functional safety (see "Additional Status displays" on page 482)
The new HR 520 and HR 550 FS handwheels are supported (see
"Traversing with electronic handwheels" on page 466)
New software option 3-D ToolComp: 3-D tool radius compensation
depending on the tool's contact angle on blocks with surface normal
vectors (LN blocks)
3-D line graphics is now also possible in full-screen mode (see "3-D
Line Graphics (FCL2 Function)" on page 150)
A file selection dialog for selecting files in different NC functions and
in the table view of the pallet table is available now (see "Calling any
program as a subprogram" on page 261)
DCM: Saving and restoring of fixture situations
DCM: The form for test program generation now also contains icons
and tooltips (see "Check the position of the measured fixture" on
page 361)
DCM, FixtureWizard: Touch points and probing sequence are shown
more clearly now
DCM, FixtureWizard: Designations, touch points and measuring
points can be shown or hidden as desired.(see "Operating
FixtureWizard" on page 358)
DCM, FixtureWizard: Chucking equipment and insertion points can
now also be selected by mouse click
DCM: A library with standard chucking equipment is available now
(see "Fixture templates" on page 357)
DCM: Tool carrier management (see "Tool Holder Management
(DCM Software Option)" on page 366)
In the Test Run mode, the working plane can now by defined
manually (see "Setting a tilted working plane for the test run" on
page 544)
HEIDENHAIN iTNC 530 13