Using The 3-D Touch Probe - HEIDENHAIN iTNC 530 User Manual

14.6 Using the 3-D Touch Probe

Overview
Note that HEIDENHAIN generally does not accept liability
for the function of the touch probe cycles unless you use
HEIDENHAIN touch probes!
The following touch probe cycles are available in the Manual Operation
mode:
Function
Calibrating the effective length
Calibrating the effective radius
Measuring a basic rotation using a line
Setting the datum in any axis
Setting a corner as datum
Setting a circle center as datum
Setting a center line as datum
Measuring a basic rotation using two
holes/cylindrical studs
Setting the datum using four
holes/cylindrical studs
Setting a circle center using three
holes/cylindrical studs
HEIDENHAIN iTNC 530
Soft key Page
Page 496
Page 497
Page 501
Page 505
Page 506
Page 507
Page 508
Page 509
Page 509
Page 509
491