Cr Encoder Strip And Its Guard Film - Brother DCPJ525W Service Manual

Hide thumbs Also See for DCPJ525W:
Table of Contents

Advertisement

9.13 CR Encoder Strip and its Guard Film

CR encoder strip
(1) At the left end of the CR frame, push the rear end of the encoder strip spring inwards,
unhook the left end of the CR encoder strip from the spring, and then unhook the right end
from the CR frame.
(2) Turn the CR encoder strip in the direction of the arrow shown below, align the rectangular
hole in the left end of the strip with the boss of the strip support and take the strip off.
Remove the encoder strip spring.
Note: Take care not to scratch or damage the encoder strip. If it is stained or damaged,
replace it.
Encoder strip spring
Lower cover
Strip support
CR frame
Assembling Note: Set the CR encoder strip so that the
motor side) and the mark
CR encoder strip
points upwards as shown above.
3-88
This should point up.
marked end is to the right (carriage
-
(3_078)
Confidential

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents