Brother DCPJ525W Service Manual page 235

Assembling Notes:
• When connecting the main drain tube and air vent tube to the ink absorber box, take care not
to connect them at an angle. Tubes connected at an angle come off easily, resulting in ink
leakage. After connection, check that there is no ink leakage.
• If you replace the ink absorber box (without replacing the main PCB), reset the purge count,
referring to Chapter 4, Section
It is also recommended that the flushing box be replaced and the flushing count be reset as
necessary since the flushing count may approach the upper limit.
4.
3-98
Confidential