Brother DCPJ525W Service Manual page 230

Assembling Notes:
• When binding ink supply tubes with two tube clamps, align four ink supply tubes in the order
of Magenta, Cyan, Yellow, and Black from bottom to up, as shown on the previous page.
Bind magenta, cyan, and yellow ink tubes from the bottom with tube clamp (1) at the right
side (viewed from the front), and then bind black, yellow, and cyan ink tubes from the top
with tube clamp (2) at the left side.
• After mounting the ink refill ASSY, route all of the four ink supply tubes through the tube
guides on the tube support plate, aligning the four colors in the order shown on the previous
page, without overlapping each other. Next, put the sponge into place and pass the ink supply
tubes through the bent section of the tube support wire.
• When securing the head joint to the head/carriage unit with the head joint spring, route all of
the four ink supply tubes in front of the guide boss as shown below.
Ink supply tubes
Head joint rubber
Upper cover
Guide boss
Head joint spring
Head joint
Carriage flat cables
Head/carriage unit
3-93
Head joint spring
Head joint
PF encoder disc
Head/carriage unit
Confidential
(3_084)