Brother DCPJ525W Service Manual page 251

(3) Remove the disc guide springs (R and L)* and separate the disc guide* from the disc guide
cover*.
Disc guide cover *
Disc guide
spring L *
Large loop
(4) Remove the disc guide sensor ASSY* from the top right of the lower cover as shown
below.
Assembling Notes:
• Mount the disc guide sensor ASSY* to the lower cover so that the actuator points to the rear
as shown above.
• The disc guide springs R and L* are not the same parts. Be careful with the orientation of
each spring. Fit each spring over the bosses on the disc guide* and its cover*, with the small
loop facing upward and inward.
Small loop
Actuator
Lower cover
(Front)
3-114
Disc guide spring R *
Boss
Disc guide sensor ASSY *
Small loop
Large loop
Boss
Disc guide *
(Front)
(3_094)
(3_095)
Confidential