Brother DCPJ525W Service Manual page 221

Assembling Notes:
• Before mounting the PS/MJ shield unit on the lower cover, pass the power supply harness
through the U-shaped cutout (shown on the previous page) provided in the lower PS/MJ
frame.
• After mounting the PS/MJ shield unit on the lower cover, check that lock "x" is caught on
pawl "y" provided on the lower cover.
• After mounting the PS/MJ shield unit, route the power supply harness, MJ (LINE) harness
and MJ (EXT) harness
• If the ferrite core of the MJ (LINE) harness
band and the band was cut off, use a new band to secure the ferrite core.
MJ (LINE)
1
harness *
(yellow)
PF/registration
sensor harness
ASSY
Paper feed motor harness
MJ (EXT) harness *
(black)
*1
through the cable guides as shown below.
ASF motor harness
(Left)
1
3-84
*1
had been secured to the lower cover with a
SDAA cover *
Grounding wire
*1
*1 For MFC only
1
Carriage motor
harness
Power supply
harness
PF/registration
sensor harness
ASSY
Main PCB
Wireless LAN PCB
harness
(3_014)
Confidential