Motor Encoder Pcb Assy - Brother DCP-1510 Service Manual

7.18 Motor encoder PCB ASSY

(1) Disconnect all harnesses and flat cable from the motor encoder PCB ASSY.
Note:
• After disconnecting the flat cable, check that the cable is not damaged at the end
or short-circuited. When connecting the flat cable, do not insert it at an angle. After
insertion, check that the cable is not at an angle.
(2) Release the two hooks to remove the motor encoder PCB ASSY from the machine.
Harness routing: Refer to
sensor PCB ASSY / pick-up
Assembling Note:
• Fold the motor encoder PCB flat cable as shown in the figure below.
Mountain fold
Valley fold
80 mm
To be connected
to motor encoder
PCB ASSY
Electrode plane
Hooks
Main motor harness
Fig. 2-40
"9. Laser unit / motor encoder PCB ASSY"
solenoid".
45° 45°
Motor encoder PCB flat cable
Fig. 2-41
2-41
New toner sensor PCB harness
Pick-up solenoid harness
Motor encoder
PCB flat cable
Motor encoder PCB ASSY
and "12. New toner
122 mm
45°
Electrode plane
15 mm
To be connected to
main PCB ASSY
Confidential