Fault Diagnosis - GE Druck ADTS 405 User Manual

Druck ADTS 405 User Manual
C : O
AUTION NLY SELECT ITEMS DETAILED IN THE FOLLOWING MENUS
CHANGES TO SAFETY LIMITS AND THE CALIBRATION DATA OF THE SYSTEM
4. The system enters the maintenance mode with the following screen display:
5. Select F3. The display shows:
6. Select F3. The display shows:
7. Select F1 and when complete, press CLEAR/QUIT three times to reset the
system.
5.5

Fault Diagnosis

If the display shows a warning or error message, refer to the above sections.
If a fault occurs, refer to the fault location chart, Figure 5-1 and Table 5-1 for possible
fault causes and recommended action.
,
INCORRECT SELECTIONS CAN CAUSE
(MAINTENANCE)
F1 Data Block
F2 Supervisor EEPROM
F3 More
(MAINTENANCE)
F1 System
F2 Hardware
F3 Error log
(MAINTENANCE)
F1 Vent System
F2 Set System Ready
F3 View Temperature
5 - 5
.
K114 Issue No. 9
5