Set-Up, Speed [Pt Temperature]; Set-Up, Mach; Set-Up, Rate Timer; Set-Up, Rate - GE Druck ADTS 405 User Manual

Druck ADTS 405 User Manual
SET-UP, SPEED, [Pt TEMPERATURE]
The function allows the value of Pt temperature to be entered, this is used in the
calculation of TAS.
Enter the Pitot temperature measured by the aircraft's Pitot temperature sensor in the
units shown on the display.
The default units of temperature measurement may be changed using CONFIG,
[UNITS], [TEMPERATURE].

SET-UP, MACH

This function allows the Mach limit to be changed or disabled. The initial Mach limit
comes from the current aircraft limits.
To change the limit enter a numeric value or select as follows:
Select [OFF] to disable the Mach limit.
Select [ON] to enable the Mach limit.
Select [DEFAULT] to restore the Mach limit from the aircraft limits in use.

SET-UP, RATE TIMER

This function allows the Wait/Time values to be set for F1, F2, and F3 of the RATE TIMER
function.
To change the times:
Select the function to be changed: F1, F2 or F3.
Enter the [WAIT] value in minutes and seconds.
Enter 00:00 if a wait is not required.
Select [TIME].
Enter the [TIME] value in minutes and seconds.
Press CLEAR/QUIT.
Select another WAIT/TIME or press CLEAR/QUIT.
See the RATE TIMER for further details.

SET-UP, RATE

This function selects automatic airspeed rate control ON or OFF.
If the automatic airspeed rate is selected (using SETUP, RATE) the airspeed rate is
automatically adjusted to simultaneously achieve both altitude and airspeed aim. This
adjustment normally requires a reduction in the rate from the aim value; the rate does
not exceed the aim value. When airspeed is automatically reduced, the display shows
RATE CAS aim as (A).
This function only applies when using Aeronautical units (ft and kts, ft and mph, m and
km/h (m/min), m and km/h (m/s), m and km/h (km/min)).
6 - 23
K114 Issue No. 9
6