The [Opt-User] Menu; Setting Fault Alarm Type - GE CGA 351 User Manual

www.DataSheet4U.com

The [Opt-User] Menu

Setting Fault Alarm Type

www.DataSheet4U.com
Setup and Calibration
After entering the User Program, access the
perform the following operations:
•
setting the fault alarm type
•
setting up the analog output
•
adjusting the display contrast
•
setting the display backlight
•
configuring the serial port
Proceed to the appropriate section for specific instructions on the
topic of interest.
To set up the fault alarm, enter the User Program as described on
page 4-1 and proceed as follows:
Cfg Cal Opt Disp
POWER ESC
Cfg Cal Opt Disp
User
Setup
Lock Menus
POWER ESC
User
Fault Alarm
Analog Output
Contrast
POWER ESC
Note: The
[Backlight]
and
above list box.
[Opt-User]
Use the [ ] and [ ] keys to
[Opt]
select
ENTER
A list of the available options
is shown. Use the [ ] and [ ]
keys to select
[ENTER]
.
ENTER
Use the [ ] and [ ] keys to
[Fault Alarm]
select
[ENTER]
.
ENTER
[Comm]
options are also available in the
December 2004
submenu to
[ENTER]
and press .
[User]
and press
and press
4-15