Configuring The Pt Setting - GE Multilin EPM 6000 Instruction Manual

Note
Note
4.3.5

Configuring the PT Setting

4–12
Press ENTER again to select the to
The value can be "1", "10", or "100". Refer to Programming the Configuration Mode
Ct-S
Screens on page 4–10 for instructions on changing values.
The value for amps is a product of the
Example settings for the
Ct-S
200/5 A: set the
Ct-n
800/5 A: set the
Ct-n
2000/5 A: set the
Ct-n
10000/5 A: set the
Press ENTER to scroll through the other
Pressing DOWN or RIGHT displays the password screen (see Reset
Mode and Password Entry on page 4–6 for details).
Press MENU to return to the main configuration menu.
and are dictated by primary current.
Ct-n Ct-S
Use the following procedure to program the PT setting.
Push the DOWN Button to scroll through the configuration mode
parameters.
Press ENTER when
screen and flashing).
and the
Ct-n
value are shown below:
value for "200" and the
value for "800" and the
value for "2000" and the
value for "1000" and the
Ct-n
Ct-d
is the active parameter (i.e. it is in the "A"
Pt
EPM 6000 MULTI-FUNCTION POWER METERING SYSTEM – USER GUIDE
CHAPTER 4: USING THE METER
(CT scaling) value.
Ct-S
values.
Ct-S
value for "1"
Ct-S
value for "1"
Ct-S
value for "1".
Ct-S
value for "10".
Ct-S
parameters.
CFG
is secondary current.