If The Memory Becomes Full While Scanning Fax Documents - Konica Minolta FX-3 User Manual

Faxing
Note
To specify a scanning area
other than the size of the loaded
document or if the document
size cannot be detected
automatically, press the [ ] key.
In the next screen that appears,
select "MANUAL", and then
press the [Yes] key.
Then, select the desired paper size, and then press the [Yes] key.
6
Press the [Yes] key.
The document is scanned.
Note
To scan the next document page, press the [Yes] key, and then
position the next document page.
7
Press the [Start] key.
H To stop the transmission, press the [Stop] key, and then press the
[Yes] key in the next screen that appears.
Once transmission is finished, a beep is sounded. If the fax could not
be sent, the transmission result report is printed (p. 6-56).

If the Memory Becomes Full While Scanning Fax Documents

If the memory becomes full while scanning a document for memory
transmission, only the pages that have been scanned are sent.
With a queued transmission (a fax transmission requested while another
fax transmission job is being performed) or timer transmission, if the
memory becomes full while scanning the document, a message appears,
allowing you to select whether to send just the scanned pages or cancel
the transmission. If the transmission is canceled, the data for the scanned
pages is deleted. After the other fax transmission or reception is finished,
check the amount of memory available, and then try sending the fax
again.
Fax Kit (FX-3)
3
3-17