To Specify Memory Tx - Konica Minolta FX-3 User Manual

4

To specify Memory TX

1
Press the [Fax] key.
The machine enters Fax mode, and
the fax screen appears.
2
Load the document to be faxed into
the Automatic Document Feeder.
H Adjust the Document Guide
Plates to fit the size of the
document.
H Load the document face up.
3
If necessary, change the
"Resolution" setting (p. 3-13).
4
Using the 10-Key Pad, enter the fax
number of the recipient.
H The fax number of a previously
programmed recipient can also
be specified. Refer to "Dialing" on page 3-1.
5
Press the [Memory TX] key, and
then check that the Memory TX
lamp lights up.
Note
If the Memory TX lamp is not lit, the direct transmission is selected.
6
Press the [Start] key to begin scanning and sending the fax.
H To stop the transmission, press the [Stop] key, and then press the
[Yes] key in the next screen that appears.
Once transmission is finished, a beep is sounded.
If the fax could not be sent, the transmission result report is printed
(p. 6-56).
4-2
Fax Transmission/Reception Methods
Fax Kit (FX-3)