Copying The Usb Memory Data To The Display - Panasonic TH-55VF1HU Operating Informations

Copying the USB memory data to the
display
1
Insert the USB memory device,
which the data has been copied, to
the USB terminal of the display for
data copy (same as the step 1 on
page 107).
2
After the [Select Copy Type] screen
is displayed, go to the step 6.
When the [Select Copy Type] screen is not
displayed, follow the steps 3 to 5 to display.
Note
●
If the USB memory containing the data for
cloning is connected in power-on state, the
[Select Copy Type] message is displayed.
3
Display [Setup] menu pressing
<SETUP>.
4
Select [OSD language] with
press <ENTER> for over 3 seconds.
The following display appears.
Options
Display software information
Software licenses
USB data cloning
LAN data cloning
Shipping
5
Select [USB data cloning] with
and press <ENTER>.
6
Select [USB Memory → Display] with
and press <ENTER>.
Select Copy Type
Display → USB Memory
USB Memory → Display
7
Select [YES] with
<ENTER>.
Data copy to the display starts.
Data from USB Memory
Do you copy the data?
YES
The following message is displayed after data copy
has finished.
Cloning finished.
Please turn off the power.
8
After data copy has finished, remove
the USB memory device from the
USB terminal.
108
English
and
and press
NO
9
Turn the power off by switching the
<Main power switch> (
( ).
The copied content is applied to the display.
●
Or, disconnect the AC cord plug from the wall
outlet.
●
When USB memory is not removed in the step
8, the message [Select Copy Type] is displayed
when the display is turned on again.
Note
● If the data is copied with [POWER button lock] set to
[On], this function operates after turning the power off,
and the <Power button (Unit)> cannot be used to turn
the power on. In this case, remove the power plug,
wait sufficient time, and then connect the power plug
again to turn the power on.
● [POWER button lock] function is only for TH-
55VF1HU.
/ ) OFF