Panasonic TH-55VF1HU Operating Informations page 27

Basic format for control data
The transmission of control data from the computer
starts with a STX signal, followed by the command,
the parameters, and lastly an ETX signal in that order.
Add the parameter as required, in accordance with the
control detail.
STX C1 C2 C3
Start Colon
(02h)
3-character command
(3 bytes)
Command
Command Parameter
PON None
POF None
AVL
AMT
IMS None
HM1
DP1
DL1
DV1
DV2
PC1
VD1
YP1
UD1
DAM
None
ZOOM
FULL
NORM
ZOM2
: P1 P2 P3 P4 P5 ETX
End
(03h)
Parameter(s)
Control details
Power ON
Power OFF
*** Volume 000 - 100
0 Audio MUTE OFF
1 Audio MUTE ON
Input select (toggle)
HDMI input (HDMI)
DisplayPort input
(DisplayPort)
DIGITAL LINK input
(DIGITAL LINK)
DVI-D IN 1 input
(DVI-D1)
DVI-D IN 2 input
(DVI-D2)
PC IN input (PC)
VIDEO input
(VIDEO)
COMPONENT input
(COMPONENT/
RGB IN)
USB input (USB)
Screen mode select
(toggle)
Zoom1
16:9
4:3
Zoom2
Note
● If multiple commands are transmitted, be sure to
wait for the response for the first command to come
from this unit before sending the next command.
When sending a command which does not require
parameter, a colon (:) is not needed.
●
If an incorrect command is sent by mistake, this
unit will send an "ER401" command back to the
computer.
●
In Standby condition (power OFF with remote control
or <Power button (Unit)>), the unit responds to PON
command only.
● When [Serial ID function] (see page 54) is set to
[On], only the command that matches the display ID
can be operated.
As the format, add the following header.
AD94;RAD=<XXX>;
For display ID, insert 001 to 100 or 000 for <XXX>.
For group ID, insert AAA (for A) to GGG (for G) for
<XXX>.
●
Consult your local Panasonic dealer for detail
instructions on command usage.
For more details, visit the following web site.
http://panasonic.net/prodisplays/
27
English