Network Environment (Multi Media Player Only); Starting / Ending Media Player; Resume Play Function - Panasonic TH-55VF1HU Operating Informations

Network environment (Multi Media
Player only)
■
Example of setting up LAN connection and
IP address / Subnet mask
As mentioned below, connect several units together with
LAN cables and set up IP addresses / Subnet masks so
that all the displays exist on the same network.
Parent
Child
Child
Child
Note
● Set [Network control] of all displays to [On]. (see
page 69)
● Depending on the network environment,
synchronization may be largely lost.
● Do not connect other devices to prevent network
traffic jam.
● With a router put in between, you cannot set up
connection. Use them within the same subnet.
● Do not use wireless LAN for connection since
playback may not be performed normally.

Starting / ending Media Player

■
For Single Media Player
Start
1. Insert USB memory for Media Player.
Note
●
Depending on the type of a USB memory device,
it may come in contact with the periphery such
as a back cover, and cannot be attached. Use a
commercially sold extension cable, or use a small
type of a USB memory device connectable to this
unit.
104
English
IP address: 192.168.10.1
Subnet mask: 255.255.255.0
IP address: 192.168.10.2
Subnet mask: 255.255.255.0
IP address: 192.168.10.3
Subnet mask: 255.255.255.0
IP address: 192.168.10.4
Subnet mask: 255.255.255.0
USB terminal
USB memory
2. Run a USB memory contents check.
3. Change INPUT to [USB].
Ending
Change INPUT to other than [USB].
■
For Multi Media Player
Start
1. Connect several units with LAN cables.
(See "Example of setting up LAN connection and IP
address / Subnet mask" in the previous section.)
2. Insert USB memory for Media Player into each
Display.
3. Executes USB memory contents check on each
Display.
4. Change INPUT for Child to [USB].
5. Change INPUT for Parent to [USB].
Ending
Change INPUT for Parent to other than [USB].

Resume Play function

After Media Player ends, the file to be resumed when
resuming playing varies depending on the setting of
[USB media player settings] - [Resume play].
When set to [On]:
The file played prior to the end of Media Player starts
playing from the beginning.
When set to [Off]:
Play starts from the beginning of the first file of the
scenario.
Note
●
The resume play function is retained until the unit is
turned off or the USB memory device is taken out.