Panasonic TH-55VF1HU Operating Informations page 82

[No signal error timing]
Set up the detecting time for no signal error.
(Range: 01 - 90, Interval: 1 minute)
●
The warning of [No signal warning] and the error
of [No signal error] are not sent when the no signal
state is detected through any of the following
functions:
[No signal power off], [HDMI power management],
[DIGITAL LINK power management], [DVI-D1
power management], [DVI-D2 power
management], [PC power management]
(see page 66)
Setting Example:
●
If there is no signal when [PC IN] is input, [PC
power management] is activated first and the
Display enters the standby mode.
[No signal warning timing]: 5 minutes
[No signal error timing]: 10 minutes
[PC power management]: [On] (60 seconds)
Note
● The [No signal error timing] cannot be set shorter
than [No signal warning timing].
● With the USB input, the unit determines no signal
is present when the USB memory is not connected
to the USB terminal.
●
In addition, even when a USB memory is
connected, if there is no playable file, the unit
determines no signal is present.
[Temperature warning]
When set to [On], the display sends out the warning
message.
82
English
Initialization
When both main unit buttons and remote control buttons
are disabled due to the [Button lock], [Controller user
level] and [Controller ID function] (see page 54) settings,
set all the values [Off] so that all the buttons are enabled
again.
Press <- (Unit)> together with <RETURN>
and hold for more than 5 seconds.
[Shipping] is displayed and the lock is released when
it disappears.
Shipping
YES
●
Settings for [Button lock], [Controller user level]
and [Controller ID function] will be back to [Off].
NO