Table of Contents
Advertisement
USB memory
network settings
Using a USB memory device, the network setting can be
made for multiple displays.
Note
●
The examples are for TH-55VF2HW model. For
TH-55VF2W model, replace "55VF2H" with "55VF2".
■
About the setting
The following items in [Network settings] - [LAN
setup] can be set.
[IP address], [Subnet mask], [Gateway], [Port]
Note
●
[Network settings] - [LAN setup] - [DHCP] is set to
[Off].
●
[Network settings] - [Network control] is set to [On].
●
Make sure that [Network settings] - [USB memory
network settings] is set to [Permit].
If it is set to [Prohibit], network setting cannot be
made with this function. (see page 71)
●
Once the network setting is done with USB memory
device, [Network settings] - [USB memory network
settings] is set to [Prohibit].
■
Supported device
●
Commercially available USB memory devices are
supported. (Those with security functions are not
supported. Operation is not guaranteed.)
●
USB memory devices other than those formatted in
FAT16 or FAT32 cannot be used.
●
Up to 32 GB of USB memory in size are supported.
●
Only single partition configuration is supported.
●
Use a writable USB memory device.
Saving the LAN setting file to the
USB memory device
Create the following files, and save them to the USB
memory device.
File name: th-55vf2h_network.sh
Setting Example
TH-55VF2H_LAN_SETTINGS
A:192.168.0.18
S:255.255.255.0
G:192.168.0.1
P:1024
I:ON
110
English
TH-55VF2H_LAN_SETTINGS:
Fixed characters representing the model name
Be sure to input.
A: Specifies the IP address.
S: Specifies the subnet mask
G: Specifies the gateway address
P: Specifies the port number
I: Setting this to [ON] can set individual IP addresses for
each main unit.
One IP address is assigned to each main unit in the
range that can be specified as an IP address.
Note
●
Deleting the rows S, G, P and I will not overwrite the
deleted setting items. The original setting contents
are retained.
●
When the row "I" is deleted, it will be set to [ON]
automatically.
●
Be sure to fill in the rows of the fixed character and
IP address.
●
If the network setting fails with this function, an error
message is displayed.
If fails, the network setting is not changed.
Be sure to confirm the file description, and insert the
USB memory device again.
●
This function operates only when a file with the above
file name exists in the USB memory device.
●
Use one-byte alphanumeric characters to describe
file contents.
Copying the USB memory data to the
display
1
Insert the USB memory device to the
USB terminal at the bottom of the
display.
2
The [LAN setup] screen is displayed
after data copy has finished.
3
Remove the USB memory device from
the USB terminal.
USB terminal
USB memory
Advertisement
Table of Contents
