3. Connect the power cord to the connector. See Figure 28.
Figure 28. Plugging in the AC Power Cord
4. Lower the retaining clip to secure the power cord to the switch. See
Figure 29.
Figure 29. Lowering the Retaining Clip
5. Connect the other end of the power cord to an appropriate power
source.
Warning
Power cord is used as a disconnection device. To de-energize
equipment, disconnect the power cord.
6. Go to "Monitoring the Initialization Processes" on page 58 or
"Configuring the Switch for Stand-alone Operations" on page 61.
XS916MX Series Installation Guide for Stand-alone Switches
E3
57