Chapter 5: Powering On the Switch
Powering On the Switch
56
Before powering on the switch, see "Power Specifications" on page 72 for
the power specifications.
To install the power cord retaining clip and power on the switch, perform
the following procedure:
1. Position the power cord retaining clip with the "u" part facing down,
press in the sides, and insert the ends of the clip into the holes in the
retaining bracket on the AC connector. See Figure 26.
Figure 26. Installing the Retaining Clip
2. Raise the retaining clip. See Figure 27.
Figure 27. Raising the Retaining Clip